Ip Address Configuration - Deviceinstaller - Caen ELS LiAM 6005 User Manual

LiAM User's Manual
5.4.2 IP Address configuration - DeviceInstaller®
If the power supply IP address is not known by the user the best way to find
out and to configure the module IP address is to use the DeviceInstaller® software.
The DeviceInstaller® software can be downloaded for free from the Lantronix
website www.lantronix.com. The LiAM modules can be connected to a global LAN
or point-to-point (recommended in order to obtain minimum delays, maximum speed
performance and to avoid possible communication problems). Please note that for a
point-to-point direct connection a twisted Ethernet cable must be used.
The next few steps must be followed in order to assign a new IP address to the
LiAM 6005 module:
 Connect to the desired LiAM module with a twisted Ethernet cable;
 Verify that the "Link LED" on the RJ45 connector is turned on (amber for a
10Mbps connection or green for a 100Mbps connection);
 Launch the "DeviceInstaller" program;
 Select the XPort device where you want to change the IP address;
 Click on the "Assign IP" icon;
 Select "Assign a specific IP address" and then click "Next";
81
Remote Control