Table of Contents
Advertisement
Safety and Installation
2.3 Injury Precautions
This section contains the fundamental safety rules for the installation and
operation of the system in order to avoid injuries.
2.3.1 Caution
The following safety precautions must be observed during all phases of
operation, service and repair of this equipment. Failure to comply with the safety
precautions or warnings in this document violates safety standards of design,
manufacture and intended use of this equipment and may impair the built-in
protections within.
CAEN ELS d.o.o. shall not be liable for user's failure to comply with these
requirements.
To avoid electrical shock or fire hazard, do not apply a voltage to a load that is
outside the range specified for that load.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or
panels removed.
Do Not Operate in Wet/Damp Conditions.
To avoid electrical shock, do not operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
To avoid injury or fire hazard, do not operate this product in an explosive
atmosphere.
Do Not Operate With Suspected Failures.
If you suspect there is damage to this product, have it inspected by qualified
service personnel.
2.4 Grounding
To minimize shock hazard, the LiAM power supply unit must be connected to
an electrical ground. The ground terminal is present on the mains sockets on the back
side of the crate and it is directly connected inside the chassis.
LiAM User's Manual
16
Advertisement
Table of Contents
