Safety and Installation
2.10 Suggested cable sections
The suggested cable sections for the LiAM rear panel connections are all
included in the range 0.2 mm
.
Table 1
AC Mains
Interlocks and Output Status
Output Terminals
Please remember connect the power supply to the EARTH ground connection
first.
2.11 Voltage Rail Fuses
The voltages used for generating the power "rails" on the LiAM output stage
are protected with two fuses (one for each rail), placed on the rear panel.
The current rating of both these fuses is 8A-T (standard 5 × 20 mm
dimension) and they are used to protect the output stages and circuitry from fault
conditions.
A simple screw-driver is needed in order to remove fuse holders and to replace
these fuses, as shown in
2
2
→ 4 mm
, i.e. 24 AWG → 11 AWG, and presented in
Table 1: suggested conductor sections
Figure 15: fuse-holder
.
Figure 15
LiAM User's Manual
2
mm
AWG
1
17
0.25
23
1.5 → 2
15 → 14
24