Table of Contents
Advertisement
LiAM User's Manual
2.5 Input Ratings
Do not use AC supply which exceeds the input voltage and frequency ratings of
this instrument. For input voltage and frequency rating of the module see Chapter 0.
For safety reasons, the mains supply voltage fluctuations should not exceed
above voltage range.
2.6 Output Connectors
Do not plug or unplug output connections when power converters are on and the
power units are regulating current on the electrical load.
2.7 Live Circuits
Operating personnel must not remove the 19" crates covers NOR touch the
external terminal screw connection that may be supplied at dangerous potential.
No internal adjustment or component replacement is allowed to non-CAEN
ELS d.o.o. personnel. Never replace components with power cables connected.
In order to avoid injuries, always disconnect power plugs directly from the wall
mains, discharge circuits and remove external voltage source before touching
components (wait 5 minutes at least).
2.8 Part Replacement and Modifications
Always disconnect power terminals, discharge circuits and remove external
voltage source prior to fuse replacement (wait 5 minutes at least).
Other parts substitutions and modifications are allowed by authorized CAEN
ELS d.o.o. service personnel only.
2.9 Installation Instructions
Follow these instructions in order to correctly install the LiAM power supply
system.
PLEASE READ THIS SECTION CAREFULLY IN ORDER TO
Install the 2U LiAM 6005 system crate in a standard 19" cabinet as shown in the
following
:
Figure 4
17
AVOID ANY SHOCK HAZARD.
Safety and Installation
Advertisement
Table of Contents
