Switching On/Off The Power; Switching On The Power; Switching Off The Power - Fuji Xerox DocuPrint 3105 User Manual

2.2

Switching On/Off the Power

Switching On the Power

1. Press the <|> side of the printer's power
switch to turn on the power.
2. "Please wait" is displayed on the display of
the control panel. Check that this display
changes to "Ready to Print".
Note
• When using the printer, the printer approximately
about 20 seconds to be ready to print after the power
is switched on. It may take longer depending on your
machine's configuration.
• If an error message is displayed, refer to "Error
Messages (in Alphabetical Order)" (P. 209) to remedy
the error.

Switching Off the Power

Important
• Do not switch the power off when the <Energy Saver> lamp is blinking. The <Energy Saver> buttom
flashes if the HDD Extension Kit (optional) is being accessed while the printer is in the power saver
mode.
• Do not switch the power off when the display reads [Please wait...].
• Do not switch the power off during printing. Doing so can cause paper jams.
• Turning off power causes any print data or other data in the printer to be deleted.
• After you turn off the power, the printer remains on for a short while as it performs an internal power off
procedure. Do not unplug the power cord immediately after turning off the power switch. To switch on the
power again, wait until the <Energy Saver> button has completely gone out.
• If, after switching off the power of the printer, you want to switch it on again, do so after waiting for 10
seconds after the message on the display of the control panel and the various lamps on the control panel
have switched off.
1. Make sure that the printer is not in
operation by checking the display or
indicator lamps.
2. Press the <
switch to turn off power.
50
2 Basic Operation
> side of the printer's power