Allocate Memory - Fuji Xerox DocuPrint 3105 User Manual

[Allocate Memory]

[Allocate Memory] changes the size of memory and form memory of each interface.
Important
• Memory is reset when its size is changed, and all data stored in each of the memory areas is deleted.
• You cannot allocate more than the total memory. When the memory allocation settings exceed the size
of mounted memory when the power is turned on, the system automatically adjusts memory allocation.
• If the printer runs out of memory when ports are set to be enabled at printer startup, the ports are
sometimes automatically disabled. If this happens, either disable unused ports, or change the memory
allocation under [Allocate Memory]. Note, however, that the parallel, USB ports are never automatically
disabled.
Note
• Memory allocation, excluding the print page buffer, can be set on the control panel or in CentreWare
Internet Services.
• The print page buffer is the area where the actual printed image is plotted. The size of the print page
buffer can be changed directly by the user. Area remaining after memory is allocated for other uses is
allocated as the print page buffer.
When printing high-resolution documents, set so that a large buffer size is allocated as print page buffer.
The actual size of the allocated print buffer can be confirmed by printing the [Configuration Report]. You
can also check it by using CentreWare Internet Services.
PS
HPGL Auto Layout
Job Ticket Memory
184
5 Control Panel Settings
(See *2 on P. 188.)
Admin Menu
Allocate Memory
Setting
Specifies the size of memory used by PostScript.
Specify memory size from 55.00 to 128.00 MB in 0.25 MB increments.
The maximum size that can be set changes according to the amount
of free memory.
• [55.00 M] (default)
Specifies the size of memory to be used in HP-GL and HP-GL/2 auto
layout.
Specify memory size from 64 to 5120 KB in 32 KB increments. The
maximum size that can be set changes according to the amount of
free memory.
• [64K] (default)
When HDD Extension Kit (optional) is installed, the HDD Extension
Kit (optional) is used for auto layout memory. In this case, the size
cannot be changed by the user, and is displayed as [HDD Extension
Kit (optional)] on the display.
Specify the amount of memory to use for job tickets from 0.25 to 8.00
MB in 0.25 MB increments.
The maximum amount of memory you can allocate varies according to
the amount of free space available in memory.
• [0.25 MB] (default)
Allocate Memory
PS
Allocate Memory
HPGL Auto Layout
Allocate Memory
Job Ticket Memory
Allocate Memory
Receiving Buffer
Description