Installing Extension System Memory - Fuji Xerox DocuPrint 3105 User Manual

A.5

Installing Extension System Memory

Extension System Memory must be installed in any of the following instances.
• To print using the print driver's Print Page Mode
Selecting [On] for [Print Page Mode] changes the printing method of the printer. When
printing large volumes of data or when the printer is taking too much time to print, change
the [Print Page Mode] setting to [On] and try printing again.
• When the low memory message appears frequently while printing
Extension System Memory also may be required to increase the number of print driver
image quality, paper sizes, and other options.
For more information about Extension System Memory and how to order it, refer to the
following section.
Note
• The amount of memory required depends on the type of print driver being used.
• The memory capacity values shown in the table below are based on the printer's initial factory default
settings. The require memory capacity depends on the printer's operating environment, enabled protocol
status, and buffer size.
• For information about Extension System Memory installed in the printer and precautions about
Extension System Memory, refer to "A.2 Options" (P. 326).
PCL print driver
Image Quality
Standard
High Resolution
Paper Size
A5
B5
A4
B4
A3
Custom Size
Long size (297 x
900 mm)
A5
B5
A4
Memory capacity
1-sided
Supported Output
Standard (512 MB)
Standard (512 MB)
Standard (512 MB)
A.5 Installing Extension System Memory
Memory capacity
2-sided
Supported Output
-
329