Error Codes - Wasp WLS9600 Product Reference Manual

Table 48
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Program- A valid programming label has
ming Mode Entry been scanned.
Label Program- A label has been rejected.
ming Mode Rejec-
tion of Label
Label Program- In cases where multiple labels
ming Mode Accep- must be scanned to program one
tance of Partial feature, this indication acknowl-
Label edges each portion as it is success-
fully scanned.
Label Program- Configuration option(s) have been
ming Mode Accep- successfully programmed via
tance of labels and the reader has exited
Programming Programming Mode.
Label Program- Cancel label has been scanned.
ming Mode Can-
cel Item Entry

Error Codes

Upon startup, if the reader sounds a long tone, this means the reader has not passed its
automatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is
reset, the sequence will be repeated. The following table describes the LED flashes/beep codes
associated with an error found.
NUMBER OF LED
FLASHES/BEEPS
Product Reference Guide
. Programming Mode Indications
1 Configuration
2 Interface PCB
4 Reader Module
5 Laser Pointer (if so equipped)
6 Digital PCB
14 CPLD/Code Mismatch
LED blinks continuously
N/A
N/A
N/A
N/A
ERROR CORRECTIVE ACTION
Contact Helpdesk for assistance
Technical Specifications
Reader sounds four low frequency
beeps.
Reader sounds three times at low-
est frequency & current volume.
Reader sounds one short beep at
highest frequency & current vol-
ume.
Reader sounds one high frequency
beep and 4 low frequency beeps
followed by reset beeps.
Reader sounds two times at low
frequency and current volume.
263