Scan Window CORD ATTACHMENT Interface cable modular connector Trigger Model Number and Serial Number appear here. Cable interface Interface cable modular connector clip To host Quick Start Guide Beeper...
Quick Start Guide SCANNER PROGRAMMING BARCODES Reset Defaults Set All Defaults Set Postamble Note: If you do not need a Postamble, scan 1 Erase All Rules. *Default Setting Erase All Rules 1 Erase All Rules Begin New Rules 2 Begin New Rules Send All Data 3 Send All Data Enter...
HOST INTERFACES Note: Cable may vary depending on configuration. Must be PS2 Port Keyboard Wedge SCANNER PROGRAMMING BARCODES Start Here if you have a USB scanner: Start Here if you have a keyboard wedge scanner. Must be powered USB port. *HID Keyboard Emulation USB OPOS Handheld IBM PC/AT and IBM PC Compatible...
TROUBLESHOOTING Scanner not working Problem No power to scanner Possible Cause Check system Resolution power; ensure power supply, if required, connected. Scanner decoding barcode, but data Problem not transmitting to host Scanner not Possible Cause programmed for correct host interface Check scanner Resolution host parameters...
SYMBOLOGIES This section provides the following information: Enable/Disable Barcodes - These barcodes allow you to enable or disable symbologies. Check Digit Barcodes - The check digit is the last character of the symbol used to verify the integrity of the data. It is always verified to guarantee the integrity of the data (applies to UPC-A/UPC-E and Code 39 only).
Quick Start Guide Transmit UPC-E1 Check Digit Transmit UPC-E1 Check Digit Do Not Transmit UPC-E1 Check Digit UPC-A Preamble No Preamble (<DATA>) System Character (<SYSTEM CHARACTER> <DATA>) System Character & Country Code (< COUNTRY CODE> <SYSTEM CHARACTER> <DATA>)
UPC-E Preamble No Preamble (<DATA>) System Character & Country Code (< COUNTRY CODE> <SYSTEM CHARACTER> <DATA>) UPC-E1 Preamble No Preamble (<DATA>) System Character & Country Code (< COUNTRY CODE> <SYSTEM CHARACTER> <DATA>) Quick Start Guide System Character (<SYSTEM CHARACTER> <DATA>) System Character (<SYSTEM CHARACTER>...
Quick Start Guide Convert UPC-E to UPC-A Enable this to convert UPC-E (zero suppressed) decoded data to UPC-A format before transmission. After conversion, the data follows UPC-A format and is affected by UPC-A programming selections (e.g., Preamble, Check Digit). When disabled, UPC-E decoded data is transmitted as UPC-E data, without conversion. Convert UPC-E to UPC-A (Enable) Do Not Convert UPC-E to UPC-A...
Quick Start Guide EAN-8/JAN-8 Extend When enabled, this parameter adds five leading zeros to decoded EAN-8 symbols to make them compatible in format to EAN-13 symbols. When disabled, EAN-8 symbols are transmitted as is. Enable EAN/JAN Zero Extend Disable EAN/JAN Zero Extend Code 128 Enable/Disable Code 128.
Quick Start Guide Enable/Disable ISBT 128 ISBT 128 is a variant of Code 128 used in the blood bank industry. Scan the appropriate bar code below to enable or disable ISBT 128. If necessary, the host must perform concatenation of the ISBT data. Enable ISBT 128 Disable ISBT 128 Code 39...
Quick Start Guide Trioptic Code 39 and Code 39 Full ASCII cannot be enabled simultaneously. Transmit Code 39 Check Digit Transmit Code 39 Check Digit (Enable) Do Not Transmit Code 39 Check Digit (Disable) Code 39 Check Digit Verification must be enabled for this parameter to function. Convert Code 39 to Code 32 Code 32 is a variant of Code 39 used by the Italian pharmaceutical industry.
Page 16
Quick Start Guide Code 11 Enable/Disable Code 11 Enable Code 11 Disable Code 11 Interleaved 2 of 5 (ITF) Enable/Disable Interleaved 2 of 5 Enable Interleaved 2 of 5 Disable Interleaved 2 of 5 Due to the construction of the I 2 of 5 symbology, it is possible for a scan line covering only a portion of the code to be interpreted as a complete scan, yielding less data than is encoded in the bar code.
Quick Start Guide Discrete 2 of 5 (DTF) Enable/Disable Discrete 2 of 5 Enable Discrete 2 of 5 Disable Discrete 2 of 5 Codabar (NW - 7) Enable/Disable Codabar Enable Codabar Disable Codabar...
Page 18
Quick Start Guide RSS (Reduced Space Symbology) The variants of RSS are RSS 14, RSS Expanded and RSS Limited. RSS 14 and RSS Expanded include stacked versions. Scan the appropriate bar code below to enable or disable each variant of RSS. Enable RSS 14 Disable RSS 14 Enable RSS Limited...
Page 22
PATENTS This product is covered by one or more of the following U.S. and foreign Patents: U.S. Patent No. 4,593,186; 4,603,262; 4,607,156; 4,652,750; 4,673,805; 4,736,095;4,758,717; 4,760,248; 4,806,742; 4,816,660; 4,845,350; 4,896,026; 4,897,532; 4,923,281; 4,933,538; 4,992,717; 5,015,833; 5,017,765; 5,021,641; 5,029,183; 5,047,617; 5,103,461; 5,113,445; 5,130,520; 5,140,144; 5,142,550; 5,149,950;...