Table of Contents
Advertisement
Programming
Programming
The reader is factory-configured with a set of standard default
features. After scanning the interface bar code from the Inter-
faces section, select other options and customize your reader
through use of the programming bar codes available in the
Wasp WDI4200 PRG. Check the corresponding features section
for your interface, and also the Data Editing and Symbologies
chapters of the PRG.
Using Programming Bar Codes
This manual contains bar codes which allow you to reconfigure
your reader. Some programming bar code labels, like the
Default Settings" on page
single label to enact the change.
Other bar codes require the reader to be placed in Programming
Mode prior to scanning them. Scan an ENTER/EXIT bar code
once to enter Programming Mode; scan the desired parameter
settings; scan the ENTER/EXIT bar code again to accept your
changes, which exits Programming Mode and returns the
reader to normal operation.
Configure Other Settings
Additional programming bar codes are available in the PRG to
allow for customizing programming features. If your installa-
tion requires different programming than the standard factory
default settings, refer to the PRG.
Resetting Product Defaults
If you aren't sure what programming options are in your reader,
or you've changed some options and want your custom factory
settings restored, scan the bar code below to reset the reader to
its initial configuration. Reference the PRG for other options,
and a listing of standard factory settings.
Factory defaults are based on the interface type. Be
sure your reader is configured for the correct inter-
face before scanning this label. See
Interface Type" on page 6
NOTE
16
19, require only the scan of that
Reset Default Settings
"Selecting the
for more information.
"Reset
WDI4200
Hide quick links:
Advertisement
Table of Contents
