Flash Off Time - Wasp WLS9600 Product Reference Manual

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with
3. Go to
4. Scan the barcode: SELECT FLASH OFF TIME SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 44. Flash Off Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
2 leading zeroes to yield two
digits)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
page 75 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Mode.
500ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT FLASH OFF TIME SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 44 for some examples of how to set this feature.
EXAMPLES
1,000ms (1 sec.) 5200ms (5.2 sec.)
10
'1' and '0'
Scanning Features
Keypad, that represent
9,900ms (9.9 sec.)
52 99
'5' and '2' '9' and '9'
257