Scancode Tables; Control Character Emulation; Single Press And Release Keys - Wasp WLS9600 Product Reference Manual

Control Character Emulation

Control character emulation selects from different scancode tables as listed in this appendix.
Each of the control character sets below are detailed by interface type in the tables. These apply
to Wedge and USB Keyboard platforms.
Control Character 00 .
special keys are located from 0x80 to 0xA1.
Control Character 01 .
Key, special keys are located from 0x80 to 0xA1.
Control Character 02 .
0xFE are intended as an extended ASCII table (Microsoft Windows Codepage 1252 — See
page 290.)

Single Press and Release Keys

In the following tables, Ar↓ means Alt right pressed and Ar↑ means Alt right released and so on.
Definitions for other keys are Al (Alt left ), Cr (Control Right ) Cl (Control Left ) Sh (shift).
This method can be used for combining Alt, Control or Shift with other keys.
Example: Consider a Control character set to 00. If AltRight+A is required before sending a
label to the host, it could be done by setting three Prefix keys in this way: 0x99 0x41 0x9A.
Product Reference Guide
Characters from 00 to 0x1F are sent as control character Ctrl+Keys,
Characters from 00 to 0x1F are sent as control character Ctrl+Capital
Special keys are located from 00 to 0x1F and characters from 0x80 to
Appendix E

Scancode Tables

283