Installing The Interface Cable - Wasp WLS9600 Product Reference Manual

Setup

Installing the Interface Cable

For Corded versions,
Figure
Figure 1. Connect/disconnect the cable
RS-232 Serial Connection
Turn off power to the terminal/PC and connect the reader to the terminal/PC serial port via the
RS-232 cable as shown in
Terminal) to supply reader power, use the approved power supply (AC Adapter). Plug the AC
Adapter barrel connector into the socket on the RS-232 cable connector and the AC Adapter
plug into a standard power outlet.
Figure 2. RS-232 Connection
6
connect the reader cable by inserting the cable into the handle as shown in
1. To remove it, insert a paper clip into the release aperture, then unplug the cable.
Figure 2. If the terminal will not support POT (Power Off the
WLS9600