Wasp WLS9600 Product Reference Manual page 259

Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a barcode to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 9. Label ID Position Options
Product Reference Guide
page 55 and scan the ENTER/EXIT barcode.
fix) by scanning the appropriate barcode in the section
Reference Figure 9 for Label ID positioning options if multiple identification features are
enabled.
ID from the section "Label ID Symbology Selection"on page
Label ID for the selected symbology.
ASCII Chart
hex digits associated with your choice of Label ID. For example, if you wish to select an
equal sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 279
mined. For the example given, the characters '3' and 'D' would be scanned. More exam-
ples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Prefix Label ID Aim ID
on the inside back cover of this manual and find the equivalent
and scan the barcodes representing the hex characters deter-
Table 39.
Bar Code Data
OR
Data Editing
"Label ID Control"on page
57.
Label ID Suffix
56.
249