Wasp WLS9600 Product Reference Manual page 247

Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates the Disable Charac-
2. Use the
3. Go to
4. Scan the barcode: SELECT DISABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 33. Disable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from
2
Chart
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
as 7 Data Bits.
ter is not used (not available).
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
page 31 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
pad, that represent the desired character/value in step 1 above. The second character will
cause a two-beep indication.
Mode.
'd'
ASCII
0x64
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT DISABLE CHARACTER VALUE SETTING
'6' and '4'
Scan ENTER/EXIT PROGRAMMING MODE
Table 33 for some examples of how to set this feature.
EXAMPLES
'}'
0x7D
'7' and 'D'
RS-232 Parameters
Data Bits
has been set
Appendix D, Key-
Disable Command
'D'
Not Used
0x44 0xFF
'4' and '4' 'F' AND 'F'
237