Intercode Delay - Wasp WLS9600 Product Reference Manual

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =
3. Go to
4. Scan the barcode: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 37. Wedge Intercode Delay Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
20, etc
page 42 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Mode.
No Delay
00
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCODE DELAY SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 37 for some examples of how to set this feature.
EXAMPLES
5 Seconds 60 Seconds
05
'0' and '5'
Keyboard Interface
Keypad, that represent
99 Seconds
60 99
'6' and '0' '9' AND '9'
241