Rs-232/Usb Com Parameters - Wasp WLS9600 Product Reference Manual

References
•
•
RTS/CTS Scan Control — RTS is asserted during transmissions. CTS gates transmissions and
controls enable and disable state of scanner.

RS-232/USB COM Parameters

Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Go to
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.
This completes the procedure. See
Table 28. Intercharacter Delay Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (pad with leading
2
zeroes to yield two-digits)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
232
RTS/XON/XOFF — RTS is asserted during transmissions. CTS is ignored. XON and
XOFF gate transmissions.
RTS On/CTS — RTS is always asserted. CTS gates transmissions.
ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
page 25 and scan the barcode: SELECT INTERCHARACTER DELAY SET-
TING.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
50ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 28 for some examples of how to set this feature.
EXAMPLES
150ms
15
'5' and '0'
Keypad, that represent
600ms 850ms
60 85
'6' and '0' '8' and '5'
WLS9600