1.5 Turning on the HC1 for the First Time
After you have initially charged your device for about 16 hours, the device is ready to be used.
You can now start up your device. You can then calibrate the display, learn some basic stylus
usage, and set up the system time zone, date and time.
Power-On Button
Turn ON your device by pressing the power button on the front panel.
1.6 Installing the Battery
Warning:
There is a risk of fire and burns if the battery pack is handled improperly. DO NOT
disassemble, crush, puncture, short external contacts, or dispose the battery pack
in fire or water. DO NOT attempt to open or service the battery pack. Dispose of
used batteries according to local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss when the main battery
pack is removed or completely discharged. This backup battery will keep the data and system
setting for up to 2 hours if the main battery is removed.
NOTE: To enable the backup battery cell to provide backup power supply, charge your device
with the main battery pack for at least 16 hours.
NOTE: To power on the device properly, make sure to replace the battery compartment cover
after installing the battery.
1.
Open the battery compartment cover by
sliding the tabs on both sides in the
direction of the arrows shown and lift the
cover up.
2.
Push up the backup battery switch to the
"ON position by using a stylus to turn on
the backup battery.
6
Wasp HC1 User Manual
Battery Compartment Tab
Backup Battery
Switch