Volume Button Board Cable - HP Elite x2 1011 G1 Maintenance And Service Manual

Volume button board cable

NOTE: The volume button board cable is included in the Slate Cable Kit, spare part number 793721-001.
Before removing the volume button board cable, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. System board (see
Remove the volume button board cable:
1. Turn the system board upside down with the docking connector toward you.
2. Release the ZIF connector (1) to which the volume button board cable is attached, and then disconnect
the volume button board cable from the system board.
3. Remove the volume button board cable (2).
Reverse this procedure to install the volume button board cable.
Battery on page 36)
WLAN module on page
WWAN module on page
Fan on page 43)
System board on page
Display panel assembly on page
37)
39)
49)
32), and then remove
Volume button board cable 55