Fingerprint Reader Board Cable - HP Elite x2 1011 G1 Maintenance And Service Manual

15. Remove the keyboard base system board (5) by sliding it up and to the right at an angle.
Reverse this procedure to install the keyboard base system board.

Fingerprint reader board cable

NOTE: The fingerprint reader board cable is included in the Keyboard Base Cable Kit, spare part number
793721-001.
Before removing the fingerprint reader board cable, follow these steps:
1. Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn
the keyboard base on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the keyboard base.
3. Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the keyboard base.
4. Remove the bottom cover (see
5. Remove the keyboard base battery (see
6. Remove the keyboard system board (see
Remove the fingerprint reader board cable:
1. Turn the keyboard base system board upside down with the front toward you.
2. Release the ZIF connector (1) to which the fingerprint reader board cable is attached, and then
disconnect the fingerprint reader board cable from the keyboard base system board.
84 Chapter 6 Removal and replacement procedures – Keyboard base
Bottom cover on page 71).
Keyboard base battery on page
Keyboard base system board on page
72).
81).