Solid-State Drive - HP Elite x2 1011 G1 Maintenance And Service Manual

Reverse this procedure to install the RTC battery.

Solid-state drive

Description
512-GB, M2, SATA-3 solid-state drive
256-GB, M2, SATA-3
256-GB, M2, SATA-3 solid-state drive supporting TLC
256-GB, M2, SATA-3, SED solid-state drive supporting Opal 2
180-GB, M2, SATA-3
180-GB, M2, SATA-3, SED solid-state drive supporting Opal 2
128-GB, M2, SATA-3
128-GB, M2, SATA-3 solid-state drive supporting TLC
Before removing the solid-state drive, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. System board (see
Remove the solid-state drive:
1. Turn the system board upside down with the docking connector toward you.
2. Remove the Phillips PM1.3×1.9 screw that secures the solid-state drive to the system board. (The solid-
state drive tilts up.)
Battery on page 36)
WLAN module on page
WWAN module on page
Fan on page 43)
System board on page
Display panel assembly on page
37)
39)
49)
Spare part number
811391-001
793709-001
811793-001
810987-001
811389-001
811390-001
793708-001
811392-001
32), and then remove
Solid-state drive 57