Touchpad - HP Elite x2 1011 G1 Maintenance And Service Manual

4. Remove the fingerprint reader board (4).
Reverse this procedure to install the fingerprint reader board.

TouchPad

Description
TouchPad (includes cable)
Before removing the TouchPad, follow these steps:
1. Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn
the keyboard base on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the keyboard base.
3. Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the keyboard base.
4. Remove the bottom cover (see
5. Remove the keyboard base battery (see
Remove the TouchPad:
1. Disconnect the TouchPad cable from the LIF connector (1) on smart card reader board.
2. Remove the four Phillips PM1.5×2.7 screws (2) that secure the TouchPad to the top cover.
78 Chapter 6 Removal and replacement procedures – Keyboard base
Bottom cover on page 71).
Keyboard base battery on page
Spare part number
793720-001
72).