Audio Jack Board - HP Elite x2 1011 G1 Maintenance And Service Manual

7. Release the ZIF connector (3) to which the docking connector board cable is attached, and then
disconnect the docking connector board cable from the docking connector board.
8. Remove the docking connector board, audio jack board, and audio jack board cable.
Reverse this procedure to install the docking connector board.

Audio jack board

Description
Audio jack board (includes cable)
Before removing the audio jack board, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see
5. Remove the battery (see
6. Remove the docking connector board (see
Remove the audio jack board:
1. Release the ZIF connector (1) to which the audio jack board cable is attached, and then disconnect
the audio jack board cable from the docking connector board.
48 Chapter 5 Removal and replacement procedures – slate
Display panel assembly on page
Battery on page 36).
Docking connector board on page
Spare part number
793732-001
32).
46).