Wwan Antenna - HP Elite x2 1011 G1 Maintenance And Service Manual

WWAN antenna

NOTE: The WWAN auxiliary and main antennas are included in the Antenna Kit, using the following spare
part numbers:
●
805065-001 – For use in African, European, and Middle Eastern countries and regions
●
806251-001 – For use in Japan
●
805067-001 – For use in North America
Before removing the WWAN antenna, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. System board (see
Remove the WWAN antenna:
1. Detach the WWAN main antenna transceiver (1) from the bottom cover. (The WWAN main antenna
transceiver is attached to the bottom cover with double-sided adhesive.)
64 Chapter 5 Removal and replacement procedures – slate
Battery on page 36)
WLAN module on page
WWAN module on page
Fan on page 43)
System board on page
Display panel assembly on page
37)
39)
49)
32), and then remove