Vibrator module
Description
Vibrator module (includes left and right vibrator modules and cables)
Before removing the vibrator module, follow these steps:
1.
Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2.
Disconnect all external devices connected to the slate.
3.
Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4.
Remove the display panel assembly (see
5.
Remove the battery (see
Remove the vibrator module:
1.
Disconnect the vibrator module cable (1) from the docking connector board.
2.
Release the vibrator module cables from the retention tabs (2) built into the bottom cover.
3.
Detach the vibrator module (3) from the bottom cover. (The vibrator module is attached to the bottom
cover with double-sided adhesive.)
4.
Remove the vibrator module.
Reverse this procedure to install the vibrator module.
42
Chapter 5 Removal and replacement procedures – slate
Display panel assembly on page
Battery on page
36).
Spare part number
793730-001
32).