HP Elite x2 1011 G1 Maintenance And Service Manual page 90

4. Remove the bottom cover (see
5. Remove the keyboard base battery (see
Remove the keyboard base system board:
1. Disconnect the fingerprint reader board cable from the LIF connector (1) on fingerprint reader board.
2. Detach the fingerprint reader board cable (2) from the top cover. (The fingerprint reader board cable is
attached to the top cover with double-sided adhesive.)
3. Release the adhesive strip (3) that secures the hinge assembly right cable to the keyboard base
system board.
4. Disconnect the hinge assembly right cable (4) from the keyboard base system board.
5. Disconnect the power connector cable (5) from the keyboard base system board.
6. Disconnect the keyboard backlight cable from the LIF connector (1) on the keyboard base system board.
7. Release the ZIF connector (2) to which the keyboard cable is attached, and then disconnect
the keyboard cable from the keyboard base system board.
8. Release the adhesive strip (3) that secures the hinge assembly left cable to the keyboard base
system board.
9. Disconnect the hinge assembly left cable (4) from the keyboard base system board.
82 Chapter 6 Removal and replacement procedures – Keyboard base
Bottom cover on page 71).
Keyboard base battery on page 72).