Wigig Antenna - HP Elite x2 1011 G1 Maintenance And Service Manual

Reverse this procedure to install the WLAN antenna.

WiGig antenna

Description
WiGig antenna (includes WiGig antenna cable and transceiver)
Before removing the WiGig antenna, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. System board (see
Remove the WiGig antenna:
1. Detach the WiGig antenna transceiver (1) from the bottom cover. (The WiGig antenna transceiver is
attached to the bottom cover with double-sided adhesive.)
2. Release the WiGig antenna cable from the retention tabs (2) built into the bottom cover.
68 Chapter 5 Removal and replacement procedures – slate
Battery on page 36)
WLAN module on page
WWAN module on page
Fan on page 43)
System board on page
Display panel assembly on page
37)
39)
49)
Spare part number
805066-001
32), and then remove