Kickstand - HP Elite x2 1011 G1 Maintenance And Service Manual

3. Remove the fingerprint reader board cable (2).
The fingerprint reader board cable is included in the Keyboard Base Cable Kit, spare part number
793721-001.
Reverse this procedure to install the fingerprint reader board cable.

Kickstand

Description
Kickstand (includes rubber feet)
Kickstand Hinge Kit
Before removing the kickstand, follow these steps:
1. Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn
the keyboard base on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the keyboard base.
3. Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the keyboard base.
4. Remove the bottom cover (see
5. Disconnect the keyboard base battery cable from the keyboard base system board (see
battery on page
Remove the kickstand:
1. Remove the four Phillips PM2.0×2.5 broad head screws (1) that secure the kickstand to the top cover.
Bottom cover on page
72).
71).
Spare part number
793715-001
793716-001
Keyboard base
Kickstand 85