Power Connector Cable - HP Elite x2 1011 G1 Maintenance And Service Manual

3. Remove the keyboard base battery (3).
Reverse this procedure to install the keyboard base battery.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn
the keyboard base on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the keyboard base.
3. Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the keyboard base.
4. Remove the bottom cover (see
5. Disconnect the keyboard base battery cable from the keyboard base system board (see
battery on page
Remove the power connector cable:
Bottom cover on page
72).
71).
Power connector cable
Spare part number
793714-001
Keyboard base
73