Power Button Board With Audio Jack Cable - HP Elite x2 1013 G3 Maintenance And Service Manual

Power button board with audio jack cable

Description
Power button board with audio jack cable
Before removing the power button board with audio jack cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Display panel (see
b. Battery (see
c. Solid-state drive (see
d. WWAN module (see
e. Camera connector bracket (see
f. IR camera (see
g. HD camera (see
h. Microphone board (see
i. Rear-facing camera (see
j. IR LED module (see
k. System board (see
l. Left speaker (see
Remove the power button board with audio jack cable:
1. Disconnect the cable from the ZIF connector on the audio jack (1).
2. Remove the Phillips M1.6×3.0 screw from the audio jack (2).
3. Remove the Phillips M1.6×2.0 screw from the power button board bracket (3).
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Display panel on page
Battery on page 36)
Solid-state drive on page
WWAN module (select products only) on page
Camera connector bracket on page
IR camera on page 45)
Front-facing HD camera on page
Microphone board on page
Rear-facing camera on page
IR LED module on page
System board on page
Speakers on page 58)
33)
38)
46)
48)
47)
50)
51)
Spare part number
L35963-001
41)
44)