Smart Card Reader Board - HP Elite x2 1011 G1 Maintenance And Service Manual

3. Remove the TouchPad (3).
Reverse this procedure to install the TouchPad.

Smart card reader board

Description
Smart card reader board
NOTE: The smart card reader board spare part kit does not include the smart card reader board cable.
The smart card reader board cable is included in the Keyboard Base Cable Kit, spare part number
793721-001.
Before removing the smart card reader board, follow these steps:
1. Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn
the keyboard base on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the keyboard base.
3. Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the keyboard base.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the smart card reader board:
1. Disconnect the TouchPad cable from the LIF connector (1) on smart card reader board.
2. Release the ZIF connector (2) to which the smart card reader board cable is attached, and then
disconnect the smart card reader board cable from the keyboard base connector board.
Bottom cover on page
Keyboard base battery on page
71).
72).
Smart card reader board
Spare part number
793711-001
79