Rear-Facing Webcam - HP Elite x2 1011 G1 Maintenance And Service Manual

Rear-facing webcam

NOTE: The rear-facing webcam is included in the Webcam Kit, spare part number 793724-001.
The rear-facing webcam spare part kit does not include the rear-facing webcam cable. The rear-facing
webcam cable is included in the Slate Cable Kit, spare part number 793721-001.
Before removing the rear-facing webcam, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. System board (see
Remove the rear-facing webcam:
1. Turn the system board upside down with the top edge toward you.
2. Disconnect the rear-facing webcam cable (1) from the front-facing webcam board.
3. Remove the rear-facing webcam (2).
Reverse this procedure to install the rear-facing webcam.
Battery on page 36)
WLAN module on page
WWAN module on page
Fan on page 43)
System board on page
Display panel assembly on page
37)
39)
49)
32), and then remove
Rear-facing webcam 61