Autopvc Config - THOMSON 516 Reference Manual

AutoPVC Commands

autopvc config

Configure autopvc.
SYNTAX:
autopvc config
where:
mode Select the autopvc mode:
The default is pseudo.
type Type of autopvc:
The default is bridge.
opmode Operational autopvc mode:
The default is partial.
overwrite Enable/disable UBR peak rate overwrite.
The default is enabled.
peakrate A number between 0 and 27786.
Represents the UBR peak rate (in kilobits per second).
Note
42
[mode = <{pseudo | passive | active}>]
[type = <{bridge | pppoerelay}>]
[opmode = <{partial | full}>]
[overwrite = <{disabled | enabled}>]
[peakrate = <number{0-27786}>]
pseudo:
enable only pseudo-ILMI (VP/VC 15/16). When connection parameters are
written to the MIB, display this information on CLI or web-interface but do not
use these parameters for configuration.
passive:
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/16). When connection
parameters are written to the MIB, display this information on CLI or web-
interface but do not use these parameters for configuration.
active:
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/16). When connection
parameters are written to the MIB, use these parameters to configure
phonebook entries, qosbook profiles and bind bridge or PPPoE interfaces on
top.
bridge
pppoerelay:
an ETHoA interface will be created, will be bound to the ILMI PVC and will be
added to the PPPoE relay as relay port.
partial: only read the ILMI VPC and VCC MIB tables
full: read all supported MIB tables.
0 indicates the linerate.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0