Switch Commands
switch mirror egress
Enable or disable the specified port to be the Mirror Egress Port.
Only one port can be the Mirror Egress Port at any one time.
But a port can be the Mirror Egress Port and the Mirror Ingress Port at the same time.
SYNTAX:
switch mirror egress
where:
port
The port to be the Mirror Egress Port.
Note
state
This parameter permits to enable/disable a port as Mirror Egress Port.
EXAMPLE:
Here port 1 is enabled as Mirror Egress Port
=>switch mirror egress port=1
=>switch mirror egress
Egress mirror port = 1
Here port 1 is disabled as Mirror Egress Port
=>switch mirror egress
Egress mirror port = 1
=>switch mirror egress port=1 state=disabled
=>switch mirror egress
=>
RELATED COMMANDS:
switch mirror capture
switch mirror ingress
342
port = <number{1-4}>
[state = <{enabled | disabled}>]
If no port number is specified, then the port number of the current Mirror
Egress Port is shown.
Define the specified port to be the Mirror Capture Port.
Enable or disable the specified port to be the Mirror Ingress Port.
REQUIRED
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0