Nat Create - THOMSON 516 Reference Manual

nat create

Create a static NAT/PAT entry.
Typically used to install specific servers behind the SpeedTouch
SYNTAX:
nat create protocol = <{<supported IP protocol name> | <number>}>
inside_addr = <ip-address>
[inside_port = <{<supported TCP/UDP port name> | <number>}>]
outside_addr = <ip-address>
[outside_port = <{<supported TCP/UDP port name> | <number>}>]
[foreign_addr = <ip-address>]
[foreign_port = <{<supported TCP/UDP port name> | <number>}>]
where:
protocol The IP protocol name (or number) of the incoming stream.
Select one of the supported protocol names (see
Names" on page
inside_addr The IP address of the local host (intended to receive the incoming traffic) behind
the SpeedTouch
Typically, a private IP address.
inside_port The port of the application on the local host.
Select one of the supported TCP/UDP port names (See
Port Names" on page
Note
outside_addr The apparent host IP address this application is running on, that is the NAT/PAT
enabled WAN IP address of the SpeedTouch
0
Use to create a template. Such a template will then be valid for any of the
SpeedTouch
assigned/negotiated IP addresses.
outside_port The apparent port number this application is running on.
Select one of the supported TCP/UDP port names (See
Port Names" on page
Note
foreign_addr The IP address of the in-front-of-NAT/PAT routable address.
0
Use to match all foreign addresses.
foreign_port The port of the routable host.
Select one of the supported TCP/UDP port names (See
Port Names" on page
Do not use
Note
RELATED COMMANDS:
nat delete
nat list
E-DOC-CTC-20040907-0010 v1.0
374) or ,alternatively, specify the protocol number.
TM
's NAT/PAT device.
375) or ,alternatively, specify the port number.
Applicable for TCP and UDP protocols only. Other protocols do not
need a port to be specified.
TM
's NAT/PAT enabled IP addresses, for example also dynamically
375) or ,alternatively, specify the port number.
Applicable for TCP and UDP protocols only. Other protocols do not
need a port to be specified.
375) or ,alternatively, specify the port number.
0 in case a foreign IP address is specified.
Applicable for TCP and UDP protocols only. Other protocols do not
need a port to be specified.
Delete a static NAT/PAT entry.
Lists NAT/PAT connection database.
TM
NAT/PAT device.
" Supported IP Protocol
" Supported TCP/UDP
TM
.
" Supported TCP/UDP
" Supported TCP/UDP
NAT Commands
REQUIRED
REQUIRED
OPTIONAL
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
253