Pppoe Rtadd - THOMSON 516 Reference Manual

pppoe rtadd

Automatically add a route configuration to the routing table.
The route is added when the specified PPPoE interface link comes up. This route configuration will determine
which local hosts are allowed to use this link and/or which remote destinations should be or should not be
reachable.
Use the command :pppoe ifdetach for this interface prior to configuring routes.
SYNTAX:
pppoe rtadd intf = <intfname>
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <string>]
[src = <ip-address>]
[srcmsk = <ip-mask(dotted or cidr)>]
[metric = <number{0-100}>]
where:
intf The name of the PPPoE interface.
dst The destination IP address for the route to be added when the link comes up.
dstmsk The destination IP mask.
Depending on the destination netmask:
Any remote destination is reachable, i.e. the PPPoE connection acts as default
route ( dstmsk=0
Only the remote (sub)net is reachable (
will be the default netmask applicable for destination IP address
Only the single remote host is reachable (
netmask in case of VLSM.
label The name of the label.
src The source IP address specification for the route to be added when the link comes up.
srcmsk The source IP mask.
Depending on the source netmask:
Everybody is allowed to use this PPPoE connection (
Only members of the same subnet as the host which opened the PPPoE
connection are allowed to use the PPPoE connection (
destination mask will be the netmask applicable for the IP address of the host
which opened the PPPoE connection.
Only the host which opened the PPPoE connection is allowed to use the PPPoE
connection (
metric The route metric, i.e. the cost factor of the route.
Practically, the cost is determined by the hop count.
E-DOC-CTC-20040907-0010 v1.0
)
dstmsk=32
). Any valid (contiguous) netmask in case of VLSM.
dstmsk=1 ). The actual destination mask
dstmsk=32
). Any valid (contiguous)
dstmsk=0 )
dstmsk=1
). The actual
PPPoE Commands
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
297