THOMSON 516 Reference Manual page 292

PPPoE Commands
servicename
pcomp
accomp
trace
concentrator
auth
restart
retryinterval
passive
silent
echo
mru
290
The Service Name for a PPPoE connection.
Tip Use the command :pppoe ifscan to see the available service names,
if any.
Try (on) or do not try (off) to negotiate PPPoE protocol compression (LCP
PCOMP).
The default is off.
Try (on), do never try (off) or negotiate (negotiate) to negotiate PPPoE address &
control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, that is the
address field FF-03 should not be sent over ATM.
The default is on.
If the accomp parameter is set to 'negotiate', the local side of the PPPoE
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
Enable (on) or disable (off) verbose console logging.
The default is off.
The access concentrator is on this side of the PPPoE connection.
Choose between:
on: the PPPoE connection is terminated on the Access Concentrator (here
TM
the SpeedTouch itself)
TM
off: the SpeedTouch
The default is off.
Select the authentication protocol.
Choose between:
pap: PAP authentication will be forced.
chap: CHAP authentication will be forced.
auto: CHAP authentication will be used. If CHAP authentication is not
successful, PAP authentication will be used instead.
The default is auto.
Automatically restart the connection when LCP link goes down (on) or do not
restart automatically (off).
The default is on.
A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on ATM level.
The default is 10.
Put the link in listening state in case LCP times out (on) or not (off).
This parameter allows to determine whether the link should be left open to wait
for incoming messages from the remote side after 10 unsuccessful tries to
establish the connection or not.
The default is off.
Do not send anything at startup and just listen for incoming LCP messages (on) or
retry up to 10 times to establish the connection (off).
The default is off.
Send LCP echo requests at regular intervals (on) or not (off).
The default is on.
A number between 293 and 8192.
Represents the maximum packet size the SpeedTouch
able to receive.
The default is 1492.
is PPPoE client.
TM
should negotiate to be
E-DOC-CTC-20040907-0010 v1.0
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL