Table of Contents
Advertisement
Outputting
Setting The Cutting Test And The Blade Force
For high-quality cutting, then before you perform actual cutting, we recommend carrying out a cutting test
to check the cutting quality for the media. Adjust the blade force depending on the cutting quality.
1.
Carrying out the cutting test
2
Press
where you want to carry out the cutting test.
You can freely set the location for the cutting test.
Close the front cover.
Hold down
The test pattern is cut.
2.
Setting the blade force.
Press
FORCE
50 gf
Pressing
conditions in addition to the blade force. Refer to the following pages. Refer to the following pages.
P. 121, "Fine-tuning the Cutting Conditions"
66
for one second or longer..
Rectangle
Circle
.
Press
50 gf
[Two shapes are peeled off together]
Raise the blade force.
[Backing paper is also cut]
Reduce the blade force.
Press
Go back to the original screen.
enters the cutting configuration menu. You can also make the settings for other cutting
to move the cutting carriage to the location
Peel off the cut shapes to verify the cutting quality.
[Two shapes are peeled off separately]
You do not need to perform the setting because the blade
force is appropriate.
[Two shapes are peeled off together/backing paper
is also cut]
Go to the next Procedure to set the blade force.
to select the value.
to enable the setting.
Advertisement
Table of Contents
