Performing A Cutting Test; Making The Setting For Blade Force - Roland XC-540 User Manual

Performing a Cutting Test

For high-quality cutting, then before you perform actual cutting, we recommend carrying out a cutting test to check
the cutting quality for the media. Before carrying out a cutting test, detach the media clamps.
Performing a Cutting Test
Peel off the cut shapes to verify the cutting quality, and make the setteing for blade force. For information on how
to make the setting, refer to the next clause.

Making the Setting for Blade Force

Procedure
–
FORCE
5 0 g f 5 0 g f
—
W 1346mm
SETUP SHEET
ROLL
Pressing enters the cutting configuration menu. You can also make the settings for other cutting conditions in
addition to the blade force. Refer to the following pages.
P.98 "Fine-tuning the Cutting Conditions"
When you're finished making all the settings, send cutting data from the computer.
P.39 "Getting Ready to Receive Data from a Computer"
Rectangle
Circle
Hold down
form a cutting test.
You can perform the cutting test at any location you
want by using
move the cutting carriage. The front cover may be open
during movement, but be sure to close it before you
press
Press .
Use to enter the value.
Press to finish making the setting, and go back to the original
screen.
3-1 Performing Cutting
for one second or longer to per-
.
Chapter 3 Using the Cutting Feature
to
47