Gateway Repeater Call Sign Programming; Repeater Group Programming; Access Repeater Setting (R1 Use); Frequency Programming (Freq) - Icom IC-9100 Instruction Manual

4.
When the repeater that was programmed in the pre-
vious item has its own gateway capability, skip this
setting and go to the next item. If the programmed
repeater uses a different gateway repeater, program
gateway repeater's call sign as described below.
!8 Push [Z](F-2) to display the "GW" item (Gateway
Repeater Call Sign).
"G" is automatically added as, or overwrites, the 8th
digit.
G W : JP3YHH G
RP–L
Ù Ú
!9 Push [EDT](F-4) to enter the repeater call sign pro-
gramming mode.
@0 Push [Ω](F-2) or [≈](F-3) to select the character to
program.
@1 Rotate [MAIN DIAL] to select the first character or
symbol ('/' only) to input.
When inputting numbers, push the appropriate key-
pad key.
bol or number.
beep sounds. If you want to reprogram, push [Ω](F-2) or
[≈](F-3) to select a character, then push [DEL](F-4) to
delete it.
@2 Repeat steps @0 through @1 to program a repeater
call sign of up to 8 characters.
mon name or call sign, up to 7 digits, in all their gateway
repeater cells. The 8th digit must be blank.
@3 Push [MENU] to save the programmed call sign.
5. R
assign and organize up to 500 repeaters in the 10
groups. Group selection is helpful for quick recall of a
desired repeater.
@4 Push [Z](F-2) to display the "GROUP" item (Re-
peater group).
GROUP:
RP–L
@5 Rotate [MAIN DIAL] to select the desired repeater
group.
's call sign is displayed, and
E D T
-
programmed, an error
-
GRP1
DV MODE PROGRAMMING
6.
The programmed repeaters can be set as an access
repeater (R1) in the DR mode. To use as R1, the re-
peater frequency, duplex direction and frequency off-
set must be programmed.
@6 Push [Z](F-2) to display the "R1USE" item (Access
Repeater Programming).
R1USE:
RP–L
@7 Rotate [MAIN DIAL] to select
as an access repeater (R1) in the DR mode.
as an access repeater (R1) in the DR mode.
hen "NO" is selected in step @7 , skip 'Frequency
W
programming (FREQ)' and go to 'Duplex direction
setting (DUP).'
go to step @8 for the access repeater (R1) program-
ming.
7.
This content appears when "
USE," as described in 'Access repeater setting (R1
USE)' above.
@8 Push [Z](F-2) to display the "FREQ" item (Fre-
quency Programming).
F R E Q :
RP–L
Ù Ú
C L R
@9 Push [EDT](F-4) to enter the frequency program-
ming mode.
RP–L F-INP :
Ù Ú
#0 Push the keypad key to input the frequency, then
push [F-INP ENT].
played frequency.
7
YES
@7 , push [Z](F-2) to
" is selected in "R1
. .
E D T
. .
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
- 17
18
19
20
21
90