Band Edge Warning Beep; About The User Band Edge Frequencies - Icom IC-9100 Instruction Manual

3
BASIC OPERATION
Frequency setting (Continued)
D
of an amateur band's frequency range. A regular beep
sounds when you tune into a range, and an lower tone
error beep sounds when you tune out of a range.
q Hold down [MENU] for 1 second to enter the Set
mode.
w Push [Y](F-1) or [Z](F-2) to select "Band Edge
Beep."
e Rotate [MAIN DIAL] to select the desired band edge
warning beep setting.
value.
r Push [MENU] to save, and exit the Set mode.
The beep output level can be set in the "Beep Level"
item of the Set mode. (p. 161)
the "Band Edge Beep" item, a total of 30 band edge
frequencies can be programmed in the "User Band
Edge" item. See the next page for details.
If "OFF" or "ON (Default)" is selected, the "User Band
Edge" item does not appear in the Set mode.
41
the default amateur band's fre-
quency range, a beep sounds.
(default)
a user programmed amateur
band's frequency range, a beep
sounds.
a user programmed amateur
band's frequency range, a beep
sounds. Also transmission is in-
hibited outside the programmed
range.
[ ] [ ]
[MENU]
SET B a n d E d g e B e e p
Ù 6 Ú
O N ( D e f a u l t )
ON (Default)
SET B a n d E d g e B e e p
Ù 6 Ú
O N ( U s e r )
ON (User) selection
Push
SET U s e r B a n d E d g e
Ù 7 Ú
D E F E D T
[User Band Edge] item
[MAIN DIAL]