Frequency Setting; Tuning With Main Dial; Direct Frequency Entry With The Keypad - Icom IC-9100 Instruction Manual

3
BASIC OPERATION
[MAIN DIAL], or you can enter it using the keypad.
D
q Select the desired frequency band.
more times until the desired frequency band is dis-
played.
1–3 times.
3 different frequencies on each frequency band can be
selected with the band key. (See "Using the band stack-
ing registers" on page 35.)
ing mode, frequency band and a version.
w Rotate [MAIN DIAL] to set the desired frequency.
If the Dial Lock function is ON, "
and [MAIN DIAL] does not function.
In this case, hold down [SPEECH/LOCK] for 1 sec-
ond to turn OFF the lock function. (p. 77)
When "LOCK/SPEECH" is selected in the
"[SPEECH/LOCK] SW" item of the Set mode, push-
ing [SPEECH/LOCK] turns OFF the lock function.
(see p. 164 for details)
D
The transceiver has a keypad for direct frequency
entry, as described below.
q Push [F-INP ENT] to enter frequencies with the
keypad.
w Push the numeric keys to input the desired fre-
quency.
1 MHz digits and 100 kHz digits.
e Push [F-INP ENT] to set the input frequency.
[F-INP ENT].
The frequency band, selected in either the
MAIN or SUB Band, cannot be selected on the other
Band.
37
-
" is displayed,
[EXAMPLE]
Band keys
[MAIN DIAL]
Keypad