Dr (D-Star Repeater) Mode Operation; Communication Form - Icom IC-9100 Instruction Manual

8
DV MODE OPERATION
DR (D-STAR Repeater) mode is used for D-STAR
repeater operation. In this mode, you can select the
pre-programmed repeaters and UR call sign by using
[MAIN DIAL].
Select your access repeater.
- The Access repeater scan is useful to find a repeater.
Select your destination call sign
Through an access repeater
: CQCQCQ
Through a zone link repeater
or gateway repeater
: Zone link repeater or
Gateway repeater name
Push PTT to transmit, release to receive.
channel (Repeater list).
D
To call a station through your local area (access) re-
peater.
(pp. 102, 104)
To call a station through your local area (access) re-
peater and a link repeater in the same zone.
(pp. 102, 104)
To call a station through your local area (access) re-
peater, gateway repeater and your destination repeater
by accessing the internet.
99
Select a zone link or gateway repeater.
If you make a call through an access
repeater, select "NOT USE ."
Through an access repeater
: NOT USE
Through a zone link repeater
: Zone link repeater name
Through a gateway repeater
: Gateway repeater name
(pp. 101, 103)
R : H I R A N O 4 3
D1 1
CS C D R > C S
Access/Area repeater (R1) selection
U : C Q C Q C Q
D1 R
CS C D R > C S
UR call sign (CQ) selection
U : J G 3 Y M K
D1 R
CS C D R > C S
UR call sign (specific station) selection
R : N A R A 4 3
D1 2
CS C D R > C S
R2 (destination repeater) selection
Programming the repeater list is required for DR
mode operation. (pp. 89 to 92)
repeater (R2) has no gateway call sign.
While operating voice communication or low-
speed data communication via the internet net-
work, some packets may be lost due to network
error (poor data throughput performance). In such
a case, the transceiver displays "
to indicate Packet Loss has occurred.
GRP3
U R DSET
CQ
U R DSET
UR
U R DSET
U R DSET
" on the display