Antenna Tuner Operation; Antenna Connection And Selection - Icom IC-9100 Instruction Manual

The IC-9100 has 2 antenna connectors for the HF/50
MHz bands, [ANT1] and [ANT2], and a dedicated an-
tenna connector for each of the 144 MHz, 430 MHz
tors.
band the IC-9100 covers.
When you change the operating band to one outside of
the current memorized antenna band, the antenna is
automatically selected for the new band. (See below)
This function is especially convenient when you use 2
antennas for HF and 50 MHz band operation.
To use the band memory, select "Auto" as the "[ANT]
Switch" option in the Set mode. (p. 163)
Once an antenna has been selected for use with a
matically selected whenever that band is accessed.
a 3.5/7 MHz antenna is connected to
[ANT1], a 21/28/50 MHz antenna is connected to
[ANT2]. When the antenna selector function is set to
"Auto," the correct antenna is automatically selected
when you changes bands.
function is disabled. In this case, you must select an
antenna manually.
1200 MHz* bands are automatically selected.
an optional antenna tuner and HF an-
tenna are connected to [ANT1] and a 50 MHz an-
tenna is connected to [ANT2].
tor is always selected during HF and 50 MHz bands
operation.
* The optional UX-9100 is required for 1200 MHz frequency
band operation.

ANTENNA TUNER OPERATION

-
(default)
3.5/7 MHz
bands
-
[ANT1]
HF
bands
[ANT1]
-
21/28/50 MHz 144 MHz
bands band
[ANT2] [144MHz ANT] [430MHz ANT]
[1200MHz ANT]
50 MHz 144 MHz
bands band
AH-4
[ANT2] [144MHz ANT] [430MHz ANT]
[1200MHz ANT]
13
430 MHz 1200 MHz
band band*
430 MHz 1200 MHz
band band*
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
158