D Band Edge Warning Beep - Icom IC-7600 Instruction Manual

3
BASIC OPERATION

D Band edge warning beep

When you tune inside or outside of an amateur band's
frequency range, a warning beep sounds. ("
may be indicated on outside of an amateur band's fre-
quency.) (p. 14)
This function can be turned OFF in set mode, if desired.
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Push [SET] (F-6) to select set mode menu screen.
• Pushing and holding [EXIT/SET] for 1 sec. also selects
set mode menu screen.
e Push [OTHERS] (F-5) to enter others set mode.
r Push [Y] (F-1) or [Z] (F-2) to select "Beep (Band
Edge)."
t Rotate the main dial to select the band edge warn-
ing beep function.
y Push [EXIT/SET] to exit the set mode.
The beep output level can be set in level set mode.
(p. 123)
When the band edge warning beep is set to "ON":
The band edge warning beep sounds (enter: Pi, exit:
Bu) according to the set mode setting as follows.
• ON (Default)
Band edge beep sounds when an operating frequency
enters or exits the default amateur band. (default)
• ON (User)
A beep sounds when an operating frequency enters or
exits an amateur band that is set in band edge screen.
• ON (User) & TX Limit
Same as the setting of "ON (User)." However, the
transmission can be made in the set frequency
range only.
To programming the band edge:
When "ON (User)" or "ON (User) & TX Limit" is
selected, [BAND] appears in the display above the
function switch (F-5), and up to 30 band edge fre-
quencies can be set in band edge screen.
q Perform the steps q to t as above, then select
"ON (User)" or "ON (User) & TX Limit."
w Push [BAND] (F-5) to enter the band edge screen.
e Push [Y] (F-1) or [Z] (F-2) to select the desired
band edge.
• Push [Ω ≈] (F-3) to select the set content for band
edge, lower or upper.
• Push [INS] (MF6) to insert a new blank band edge line.
• Push and hold [DEL] (MF7) for 1 sec. to delete the
selected band edge line.
• Push and hold [DEF] (F-4) for 1 sec. to display the
band edge initialize screen. Then, push and hold
[OK] (F-5) to initialize all band edge frequency settings.
r Input the desired frequency with the keypad.
• Push [GENE •] to input ". (decimal point)" between the
MHz units and kHz units.
• Program the frequency in ascending order.
• The frequency that is duplicated or out of an amateur
band cannot be programmed.
t Push [EXIT/SET] to exit the set mode.
31
When the transverter function is in use, the band
"
edge warning beep sounds with the default setting.
F-1
ON (Default) (default)
[DEL] [INS]
F-1 F-2
• Band edge screen
NOTE: All frequency ranges are set in default. So
you should delete or change it to add the desired
band edge frequency.
SET
OTHERS
F-5 F-6
Main dial
F-2 EXIT/SET
Appears
ON (User)
/
BAND OK
Keypad
F-5
Main dial
F-3 F-4 EXIT/SET
DEF