4024-110
Fuser cooling fan removal
1.
Remove the rear RIP card cover. See
2.
Remove the rear motor cover. See
3.
Disconnect the connector from the fuser cooling fan (A) from the dual drive motor assembly (B).
4.
Release the two hooks securing the fuser cooling fan (A) to the fan duct (C).
5.
Remove the fuser cooling fan (A).
Rear
Note: Before reinstalling, the fuser cooling fan (A) must be installed with the center label facing outward.
4-96
Printer Service Manual
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
Hooks
4-125.
4-14.
A
C
B