4024-110
Dual drive motor assembly removal
1.
Remove the rear RIP card cover. See
2.
Remove the rear motor cover. See
3.
Remove the exit 1 top cover. See
4.
Open the printer left door assembly.
5.
Remove the PC cartridge.
6.
Remove the exit 1 drive belt. See
7.
Disconnect the two harness connectors from the dual drive motor assembly (A).
8.
Remove the two screws securing the bracket (B).
Connector
Connector
9.
Remove the four screws securing the dual drive motor assembly (A) to the printer.
10.
Remove the dual drive motor assembly (A).
Note: Depress the spring loaded gear (C) while removing the dual drive motor assembly (A) to prevent
damage.
Warning: Before reinstalling, depress the spring loaded gear (C) while replacing the dual drive motor assembly
(A) to prevent damage.
4-114
Printer Service Manual
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
"Standard exit 1 top cover removal" on page
"Exit 1 drive belt removal" on page
A
4-125.
4-14.
4-112.
4-113.
C
Rear