4024-110
Media feed unit drive gear - 29 tooth removal
1.
Remove the appropriate media feed unit assembly. See
page 4-18
2.
Remove the harness from the bracket (A).
3.
Remove the three screws securing the bracket (A) to the media feed unit assembly.
4.
Remove the bracket (A).
Note: The gears may become detached from the bracket (A).
5.
Remove the media feed unit drive gear - 29 tooth (B).
Clamp
4-40
Printer Service Manual
or
"Media feed unit assembly 2 removal" on page
Harness
A
Rear
"Media feed unit assembly 1 removal" on
4-21.
Washer
Rear
B