Lexmark W850n Service Manual page 29

Error code or
Error contents
message
282.00 Sensor (finisher media
entrance) on jam
Paper jam
Check area F
282.01 Sensor (finisher media
entrance) Static jam A
Paper jam
Check areas
F
283.00 Sensor (buffer path) on jam A
Paper jam
Check areas
G, G4
283.01 Sensor (buffer path) on jam B
Paper jam
Check area
G2
283.02 Sensor (buffer path) Static
jam A
Paper jam
Check areas
G2, G3
283.03 Sensor (buffer path) Static
jam B
Paper jam
Check areas
G2
283.04 Sensor (buffer path) Static
jam C
Paper jam
Check areas
G4
284.00 Sensor (lower media exit) off
jam A
Paper jam
Check area F
284.01 Sensor (lower media exit) on
jam A
Paper jam
Check area F
Description/Action
Sensor (finisher media entrance) is not turned on
with the specified time after the sensor (bridge unit
media exit) is turned on.
Refer to Finisher Service Manual.
Paper remains on the sensor (finisher media
entrance).
At this time, the sensor (bridge unit media exit) is
turned on.
Refer to Finisher Service Manual.
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media
entrance is turned on.
Refer to Finisher Service Manual.
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media exit)
is turned on.
At this time, the sensor (diverter gate) is turned on.
Refer to Finisher Service Manual.
Paper remains on the sensor (finisher buffer path).
At this time, both sensor (diverter gate) and sensor
(transport exit) are on state.
Refer to Finisher Service Manual.
Paper remains on the sensor (finisher buffer path).
At this time, the sensor (diverter gate) is on state but
the sensor (finisher media entrance) is turned off.
Refer to Finisher Service Manual.
Paper remains on the sensor (finisher buffer path).
At this time, the sensor (diverter gate) is turned off.
Refer to Finisher Service Manual.
Sensor (lower media exit) is not turned off within the
specified time after the finisher sensor (lower media
exit) is turned on.
At this time, the sensor (bridge unit media exit) is
turned off.
Refer to Finisher Service Manual.
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media
entrance) is turned on.
At this time the sensor (bridge unit media exit) is
turned on.
Refer to Finisher Service Manual.
4024-110
2-9
Diagnostic information