Media Feed Unit Drive Gear - 13 Tooth Removal - Lexmark W850n Service Manual

4024-110

Media feed unit drive gear - 13 tooth removal

1.
Remove the appropriate media feed unit assembly. See
page 4-18
2.
Remove the harness from the bracket (A).
3.
Remove the three screws securing the bracket (A) to the media feed unit assembly.
4.
Remove the bracket (A).
Note: The gears may become detached from the bracket (A).
5.
Remove the tray lift one-way clutch. See
page 4-32.
6.
Remove the tray lift one-way gear 24 tooth. See
page 4-32.
7.
Remove the media feed unit drive gear - 13 tooth (B).
Clamp
Note: Before reinstalling, ensure all gears and washers are securely attached to the bracket (A).
4-34
Printer Service Manual
or "Media feed unit assembly 2 removal" on page
Harness
A
Rear
"Media feed unit assembly 1 removal" on
4-21.
"Tray lift one way clutch / gear assembly removal" on
"Tray lift one way clutch / gear assembly removal" on
Washer
Rear B